Product Details:
Model Name/Number | AP8 |
Rated Voltage | 6V DC |
Rated Current | 33mA |
Operating Temperature | -20 Deg C to 55 Deg C |
Operating Humidity | 45 to 85% RH |
Weight | 7.5 g |
Power Consumption | Max 1.6 VA |
The AP series of pilot lights offer a simple, low cost solution to panel mounted indicating light needs. Available in four panel cutout diameters, with either dome or flat lenses, all units use an integral LED array with built in current limiting resistor. All models mount with a locking ring that fastens from behind the panel, rendering them tamperproof from outside the panel. Termination is via solder terminals of various sizes, depending on the panel cutout. Available in 5V DC, 12V AC/DC or 24V AC/DC; there are also optional snap-on transformers and a DC-DC converter to support higher voltages.
Product Details:
Brand | IDEC |
Operating Temperature | -20 Deg C to 55 Deg C |
Operating Humidity | 45-85%RH |
Wire Size | AWG16 to AWG14, 2 wires |
Weight | 18 g |
Rated Current | 24mA |
Now available in 12V DC, 24V AC/DC or 120V AC, the AP22M series of pilot lights use high-intensity LEDs to provide ultra-bright visibility even in direct sunlight! These lights are perfect for use in applications located in dirty environments, or with high ambient light levels, such as waste water treatment plants, car washes, and solar or outdoor control panels. AP22M is available in six vibrant color lenses or with a clear lens to provide sharper contrast between lit and unlit. When viewed from the side, these lights provide illumination up to 100 times brighter than a standard pilot light. You need to see it to believe it!
Product Details:
Brand | IDEC |
Model Name/Number | HW1Z |
Weight | 87g |
Operating Voltage | 100/110V AC |
Current Draw | 2.4VA |
Rated Insulation Voltage | 600V |
Operating Humidity | 35 to 85% RH |
Dielectric Strength | 2,500V AC, 1 minute |
Product Details:
Model Name/Number | LD6A |
Brand | Orbital |
Temperature | -20 Deg C to 55 Deg C |
Degree of Protection | IP 65 |
Volume | 70dB to 90dB |
LD6A SignaLights utilize LED technology to provide a bright solution for supervising workstations or indicating the status of a process. These light towers have a unique ellipse lens shape and modern design, which uses a contrast of illuminated and non-illuminated areas to provide sharper illumination and increased visibility of status.Optional clear lenses provide a sharper contrast to help avoid confusion about whether a signal is on or off. Lenses are also available in red, yellow, blue, green and pure white, which work with 24V DC base units.All LD6A light towers come prewired and preconfigured, eliminating time-consuming wiring. All colored tiers come with color-coded wires, ready-to-operate right out of the box without additional assembly and wiring. All units also come with mounting screws and washers.